+86 027-65523878 [email protected]

Blog

blog

How to connect eight network cables to the crystal head?

:2025-04-10

  The method of connecting the crystal head with eight network cables usually follows the international standard T568B or T568A line sequence. The following are the detailed steps based on the T568B standard:

  Prepare tools and materials

  Crimping pliers

  Crystal head

  Eight network cables (the outer skin has been peeled to reveal the inner core)

  Line arrangement

  Arrange the eight network cables according to the line sequence of the T568B standard, from left to right: white orange, orange, white green, blue, white blue, green, white brown, brown.

  Three, the wire core is cut evenly

  Use scissors or crimping pliers to cut the aligned wire cores to ensure that each wire core is the same length and is about half a centimeter (5 mm) away from the outer skin of the wire.

  Fourth, insert the crystal head

  Insert the cut wire core into the slot of the crystal head to ensure that the wire core is in good contact with the metal touchpoint of the crystal head.

  Be careful not to confuse the line sequence and maintain consistency with the T568B standard.

  Compact the crystal head

  Put the crystal head inserted into the wire core into the corresponding slot of the crimping pliers.

  Compact the crystal head vigorously to ensure that the wire core does not loosen, and the crystal head is tightly combined with the outer skin of the mesh wire.

  Test connection

  Use the network cable tester to test the connected network cable to ensure that the connection is normal.

  During the test, insert both ends of the network cable into the corresponding interface of the tester, and observe whether all the indicator lights of the tester are on to determine whether the network cable is connected.

  Precautions

  When peeling the outer skin of the mesh wire, be careful not to cut the inner core.

  When inserting the crystal head, make sure that the wire core is pushed to the innermost part of the crystal head to avoid poor contact.

  When compacting the crystal head, the force should be moderate to avoid damage to the crystal head or wire core.

  Through the above steps, you can successfully connect the eight network cables to the crystal head. Whether it is used to connect a computer to a router, switch and other devices, or to make a cross cable to connect two identical devices, you can follow this method for wiring.

Anna YAO:+86 15099905597
kelly:+86 15727116558
Alice:+86 13249827189
Crystal:+86 18571468029
Merrin:+86 18771689952
WeChat QR Code 1
WeChat QR Code 2

: +86 027-65523878

返回顶部